Adaptec 6405 RAID funktioniert seit FW-Update nicht mehr

Hallo,
beim FW Update ist vorhin anscheind etwas verkehrt gelaufen.
Das Update habe ich mit der RAID Überwachung vorgenommen (Maxview Storage Manager)
Letzte Meldung war, dass das System neugestartet wird. Eine halbe Stunde wartete ich ab aber es passierte nichts.
Server neugestartet: Und Boom "No Bootdevice selected". Nun habe ich einen Anleitung von Adaptec gefunden, wie man einen
reset des Controllers vornimmt. Nur verstehe ich diese nicht ganz. Kann mir jemand die Anleitung erklären?


Hier die Anleitung

This section explains how to reset (orMode 0 flash) your Adaptec RAID controller. You may
want to do this if the controller becomes inoper
able, or if a firmware upgrade is unsuccessful.
To reset your Adaptec RAID controller:

1
Download the firmware version currently installed on your controller from
www.adaptec.com.

2
Extract the down-loaded files to a folder on your local hard drive (for example,
C:\Download\Drivers).

3
Copy the file AFU.exe (from the RAID Controller installation DVD) and the firmware
image files (typically *.ufi) to a bootable DOS floppy disk, USB flash drive, or writable CD-ROM.

Note:
Due to space limitations with floppy disks, you may need to create a bootable DOS
floppy disk for each firmware image.

4
Power off your computer, disconnect the power cord, then open the cabinet following the
manufacturer’s instructions.

5
Disconnect all cables from the controller, then attach a shorting jumper to the Mode 0
flash connector.

Note:
To locate the Mode 0 flash connector on your Adaptec RAID controller, see the
figures in About Your RAID Controller on page 17. On Adaptec Series 6/6E controllers, the
label on the flash connector is “HDA mode.”

6
Reconnect the power cord, power on your computer, then boot to the drive containing the
AFU.exe file (see Step 3).

7
At the prompt, type
<drive-letter>:\afu update /c x wheredrive-letteris the drive identifier (afor a floppy drive, for instance) and x is the controller number.
Note:
You will be prompted to insert other disks, as needed.

8
When the flash is complete, power off your computer, disconnect the power cord, then
remove the jumper.

9
Close the computer cabinet, reconnect the power cord, then power on your computer.
The controller should boot correctly